Bq5124 Stereo Line Input Channel - Calrec M3 Operator's Manual

M3
............................................................................................................................... . ...................................................

BQ5124 STEREO LINE INPUT CHANNEL

Routing
Tone
L/R
ØL
Mono
Trim
HF Filter
LF Filter
3 band equaliser :
HF shelf
MID bell
LF shelf
EQ in/out button (includes filters) red LED
Direct Output gain control, 10dB in hand (can be internally selected pre or post fader).
TB
MM
Aux 4
Aux 1-3
Scribble strip
ISOL
INS
CUT
AFL
Peak
3 LEDs
ON
FDR
START
PFL
Fader
48
: 2 main stereo outputs and up to 4 mono or stereo groups
: Red button switches alignment tone to the channel post mic gain control but pre
the trim - Inhibited on air.
: Input balance control. +3/0/off.
: Phase reverse left leg.
: Switches both inputs to both outputs.
: ± 15dB.
: 1 button : 10kHz
: 2 buttons : 47Hz, 82Hz, both 120Hz
: ± 15dB at 10kHz or 5kHz (button pressed)
: ± 15dB frequency variable from 250Hz to 4kHz
: ± 15dB at 60Hz or 160Hz (button pressed)
: Talkback button to direct output.
: Push button selects Mix-Minus buss to either the channel direct output or as a
channel contribution to a common Mix-Minus buss (both the direct o/p and the
MM contribution can be internally selected pre or post fader).
: Stereo output to aux 4 buss, selectable pre or post fader and on/off. Follows
channel pan.
: Mono outputs to aux 1 to 3 busses with individual level, pre/post and on/off
controls.
: Isolates external VCA control.
: Selects insert circuit (pre or post fader or bypassed are internal options).
: Latching button cuts all pre and post signals except: insert send (if internally
selected pre) and PFL, yellow LED.
: Latching button routes channel left/right signal in Stereo to the AFL mix which is
fed to the monitor loudspeakers, automatically over-riding the normal feed.
: Red LED illuminates when the signal anywhere in the module is within 3dB of
clipping.
: Bar display shows pre EQ signal level relative to 0dBu.
: Green LED illuminates to show channel fader open.
: Button fires remote start/cue when fader is open.
: Button fires remote start/cue when pressed, green LED.
: Latching button routes pre-fader channel signal to the small PFL loudspeaker
(with internal option to inject into the main monitor chain).
: With 10dB in hand.