Lc5127 Main Output 1 And Aux Masters - Calrec M3 Operator's Manual

M3
............................................................................................................................... . ...................................................

LC5127 MAIN OUTPUT 1 AND AUX MASTERS

Direct AFL
Direct PFL
Direct CUT :
Direct PAN :
Direct level :
Main output Compressor, may be used as a Limiter (50:1 ratio) 20dB Gain reduction, Yellow LEDs.
Normally pre fader can be set POST fader (with button pressed).
RECOVERY AUTO
RECOVERY FAST
ATTACK
Dynamics IN button
RATIO
THRESHOLD
GAIN make-up
TB
TONE latching button
Aux 1-4
CUT
TB
Scribble Strip
INS
ON
PFL
FADER
56
: Latching button routes direct input after fader signal exclusively to monitor
loudspeaker.
: Latching button routes direct input pre fader signal to small PFL loudspeaker.
Latching button cuts direct input signal.
Control pans Stereo direct input signal
Control sets direct input signal level, 10dB in hand.
: Sets recovery to between 0.1 to 1.5 secs, programme dependant.
: Changes recovery time from 1 secs to 75ms (overridden by AUTO
button)
: Normal 4ms @ 5:1 ratio or FAST 0.2ms @ 5:1 ratio
: Red LED.
: 1.5 to 50:1 variable control.
: -20 to +10dBu, variable control.
: 0 to +20dB variable control.
: Talkback momentary button, inoperative ON AIR.
: Inoperative ON AIR.
: Output level controls +10dB in hand.
: Output CUT buttons.
: TB Talkback buttons (momentary).
: Insert button - Selects main output insert (pre fader).
: Green LED Illuminates when fader is open.
: Latching button routes main output pre fader signal to small PFL loudspeaker.
: With 0dB in hand.