Technical Specification - Kontron aFLAT Series Manual

1.7
These values were measured with OSD-Panel attached and without
flatpanel and backlight inverter.
- Supply voltage at 25˚C :
Minimum supply voltage : + 11,4 V DC
Typical supply voltage
Maximum supply voltage : + 12.6 V DC
- Typical Input current at 25˚C :
CRTtoLCD-6-SM with input signal (XGA) : 250 mA
CRTtoLCD-6-SM with powerdown
CRTtoLCD-6-SM without input signal
- Supply voltage ripple : 100 mV peak to peak 0 – 20 MHz
- Current Rating of the output circuits:
PANEL_VCC ( 12V, 5V or 3.3V )
Backlight Power for XGA-Flatpanel (5V or 12V) : 2A
Backlight Power for SXGA-Flatpanel 5V = 2A, 12V = 2,5A
If ( Panel_VCC = 5V and Backlight Power = 5V ) =
2,5A – Panelcurrent = max. Backlight current
VGA connector signals :
Sync input voltage low : 0.8 V
Sync input voltage high : 2.4 V
RGB input voltage
RGB input current
- Temperature :
(*1) The maximum temperature on the module surface can exceed above
mentioned ambient temperature. It is the user responsibility to keep this
temperature within the above specification.
- Thermal gradient : operating
- Relative Humidity : operating
- Mechanical : Shock
- Altitude : operating
- Dimensions of the printed circuit board :
- Dimensions of the module :
15.04.2004

Technical Specification

: + 12,0 V DC
: 0 – 0.7 V with 75 Ohm external termination
: 0 – 5 mA
Ambient
Non operating : - 10˚ C – 85˚ C
non-operating : 40˚ C per hour
non operating : 5% - 95% RH non-condensing
: 50G/20ms square wave maximum
Vibration : 1G/0-600Hz, dwell not to exceed
: 0 – 3000 m
non-operating : 0 – 5000 m
Width
Length
Thickness :
Width
Length
Height
CRTtoLCD-6-SM
: 45 mA
: 65 mA
: 2A
: 0˚ C – 60˚ C (*1)
: 25˚ C per hour
: 10% - 90 % RH non-condensing
: 70.00 mm
: 162.40 mm
1.00 mm
: 70.00 mm
: 162.40 mm
: 7.00 mm
Kontron Hamburg GmbH & Co.KG
Marschnerstieg 7
22081 Hamburg / Germany
Fon: +49 (0)40 20 00 90-0
Fax: +49 (0)40 20 00 90-10
http://www.kontron-hh.com
Page 15 of 18