Anywire Bitty Side - Mitsubishi Electric CC-Link-AnyWire Bitty Bridge User Manual

5.2

AnyWire Bitty Side

(1) Specification selection switch (MODE switch)
Set the number of occupied stations of CC-Link and that of transmission points of AnyWire Bitty using the
specification selection switch (MODE switch).
SW-1, 2: Set the transmission specification using a combination of ON/OFF for 1 and 2.
SW-3 to 6: System reserve (Set the switch to OFF. Using the module with this switch set to ON may cause
malfunction.)
Specification selection switch
1
OFF
ON
OFF
ON
● Switch off the power supply before operating the specification selection switch.
● Always set the specification selection switch according to the number of transmission points being used.
● The specification selection switch is recessed from the front surface. When setting the switch, use a precision driver or a
similar tool and be careful not to damage any of the internal boards.
34
Specification
selection switch
(MODE switch)
Number of occupied
stations of CC-Link
2
OFF
OFF
ON
ON
Number of transmission points of AnyWire Bitty
Input
4 256 points
3 192 points
2 128 points
1 64 points
Output
256 points
192 points
128 points
64 points