Setting On The Program - Mitsubishi Electric CC-Link-AnyWire Bitty Bridge User Manual

7.2

Setting on the Program

This section provides an example of the setting for MELSEC-QnA series systems.
(1) List of devices used in the program example
Device
X0
X1
X6
X7
XF
X1000 to X107F
Y0
Y6
Y60
Y1000 to Y107F
M0
M10
M100
D0 to D4
D1000 to D100F
D1100 to D110F
Module failure
Data link status of the host station
Successful completion of data link startup by parameters of the buffer memory
Data link startup error by parameters of the buffer memory
Module READY
Remote device RX
Refresh instruction
Data link startup request by parameters of the buffer memory
Signal output when data link has an error
Remote device RY
Signal in which data link status is stored
Pulse signal to start the network parameter setting
Master control contact
Device for setting the network parameter
Remote register (input from the AnyWire Bitty side)
Remote register (output to the AnyWire Bitty side)
CHAPTER 7 PREPARATION FOR OPERATION
Description
7
43