Chapter 8 Power-On And Part Indication - Mitsubishi Electric CC-Link-AnyWire Bitty Bridge User Manual

CHAPTER 8
Check each connection before turning the power on.
The status of the indicator is as shown below when each setting and connection are correct.
(1) LED indication on the NZ2AW1C1BY
LED on the CC-Link side
Indicator
RUN
ERR.
SD
RD
(2) LED indication on the slave module
Check the LED indication mentioned above before performing the automatic address detection. ( Page 48,
Section 9.1)
When the indication is different from the information above, check the indication condition and possible cause,
and then eliminate the problem according to the troubleshooting steps. ( Page 55, CHAPTER 12)
● Registering a slave module by performing the automatic address detection enables the disconnected transmission cable
location detection function.
● Data is transmitted regardless of whether the automatic address detection is performed.
● The LINK LED is turned on in red at the initial power-on because the connection terminal is not registered. Press the SET
switch to perform the automatic address detection. ( Page 48, Section 9.1)
POWER-ON AND PART INDICATION
Status
On
Off
On
On
LED on the AnyWire Bitty side
Indicator
LINK

CHAPTER 8 POWER-ON AND PART INDICATION

LED
indicator
LED on the AnyWire Bitty side
Indicator
LINK
SET
RDY

Status
Flashing
8
Status
Flashing
Off
On

45