Table of Contents
Advertisement
CHAPTER 1
This manual describes the specifications, part names, and settings of the NZ2AW1C1BY CC-Link–AnyWire Bitty
bridge module (hereafter abbreviated as the NZ2AW1C1BY) used as a remote device station in the CC-Link system.
This module, a product of the joint development project with Anywire Corporation, allows the AnyWire Bitty system to
be connected with CC-Link.
The AnyWire Bitty system provides a high-speed and highly reliable sensor network system.
(1) Features of the NZ2AW1C1BY
The NZ2AW1C1BY is the bridge module used for the connection between AnyWire Bitty having the DC
transmission cable system and CC-Link.
Disconnections can be detected even when the wiring is branched.
Up to 256 remote input points and 256 remote output points can be connected to one NZ2AW1C1BY module.
MELSEC-Q series
(2) Configuration of the AnyWire Bitty system
For the number of connectable slave modules, refer to the following.
Page 14, Section 2.2.1
OVERVIEW
CC-Link
AnyWire Bitty
AnyWire Bitty
*1
terminating unit
*1: Manufactured by Anywire Corporation
AnyWire Bitty
*1
remote I/O module (input)
AnyWire Bitty
*1
remote I/O module (output)
CHAPTER 1 OVERVIEW
1
11
Advertisement
Table of Contents
Troubleshooting
