Maintenance - U-Line H-1335 Quick Start Manual

MAINTENANCE

WARNING! Before servicing, always disconnect
the tool from the air supply, empty the
magazine and read the section Safety warnings
before starting maintenance.
Check the proper functioning of all safety devices daily.
Carefully inspect:
• The trigger and safety yoke move freely without
binding or sticking.
• All screws and nuts are securely tightened.
This tool does not require special servicing. It only needs
regular cleaning with a non-aggressive (noncorrosive)
cleaning agent.
CAUTION! Do not remove any parts for cleaning
purposes.
LUBRICATION
The tool needs a small amount of lubricating oil in the
nipple each day or approximately 10 drops once a
week to ensure a safe function and endurance. For high
frequency stapling we recommend lubricating oil.
Grease sliding or moving parts with multipurpose grease
if they have been cleaned or replaced.
PAGE 3 OF 9
SERVICING THE STAPLER
CLEARING JAMS
Generally you will not need to disassemble any parts to
clear jamming in the nozzle plate.
1. Pull the locking device forwards until the nozzle
2. Carefully remove the
3. Reset the latch.
1-800-295-5510
uline.com
plate opens.
staple with a flat pliers.
0421 IH-1335