Maintenance; Clearing Jams - U-Line KIHLBERG H-U40 Manual

STAPLING
1. Place tool against box and press down until surface
is compressed.
WARNING! Always disconnect the tool from the
air supply, empty magazine and read safety
warnings before starting any maintenance.
CAUTION! Do not remove any parts for cleaning
purposes.
This tool does not require special servicing and only
needs regular cleaning with a non-corrosive cleaning
agent.
DAILY:
Check the proper functioning of all safety devices.
Carefully inspect the following:
• Trigger and safety yoke move freely without binding
or sticking.
• All screws and nuts are securely tightened.
LUBRICATION
Use a small amount of lubricating oil in the nipple each
day (approximately 10 drops once a week) to ensure
safe function.
Grease sliding or moving parts with multipurpose grease
if they have been cleaned or replaced.
PAGE 3 OF 9
OPERATION CONTINUED
2. Pull the trigger.

MAINTENANCE

CLEARING JAMS

Generally, you will not need to disassemble any parts
to clear jamming in the nozzle plate.
1. Grip the staple with a pair of flat-nosed pliers at
2. Carefully remove the staple with flat pliers.
1-800-295-5510
uline.com
NOTE: One staple will be dispensed per
trigger pull.
the exit from the front nozzle plate. (See Figure 8)
(See Figure 8)
Figure 8
0424 IH-1440