I.i. Mini Voltage Supply And X-Ray Image Intensifier - Siemens POWERMOBIL Manual

3 - 8
Fig. 19

I.I. mini voltage supply and X-ray image intensifier

NOTE
•
Connect the Lemosa plug connector in the C-arm. Insert the plug connector into the
C-arm. Run the cable in the C-arm so that it is positioned at the side underneath the met-
al cover (1/Fig. 19).
•
Insert the control and high-voltage sections of the I.I. mini voltage supply in the C-arm.
•
Plug in the connection cable (ribbon cable) between control section and high-voltage
section.
•
Attach the X-ray image intensifier in the (suspended) service position.
•
Fasten the ground wire connections to the image intensifier.
•
Connect the high-voltage cable as well as the cables E1, E2 and E3.
•
Connect the black cathode cable of the X-ray image intensifier to the CON1.8 plug.
•
Connect the CON1 plug to the control section.
•
Attach the camera plug M4 X1 to the mounting bracket.
•
Connect the plug M30 X1.
•
Fasten all cables using cable ties.
•
Lift the X-ray image intensifier, and carefully thread in the cables. Guide the high-voltage
cable, the cable E3 and the protective ground wire through the bracket (1/Fig. 20).
Insert the ribbon cable between control section and HV section of the I.I. mini voltage
supply, at the side between the metal cover (1/Fig. 19) and the C-arm.
•
Fasten the image intensifier.
POWERMOBIL
To avoid blocking camera rotation after fastening the X-ray image
intensifier make sure that all cables are run carefully during
installation.
SPR2-240.841.01
Rev. 01
Fig. 20
Page 8 of 10
05.03 CS PS 24
Installation
3
Siemens AG
Medical Solutions