Table of Contents
Advertisement
Chapter 5
))))))))))))))))))))))))))))))))))))))))))))
^A
^D
Command
56
End of Tag Fields: Select RAM format.
57
Enter Tag Format Mode: This tells the printer that information for a tag layout is
following
67
Load Logo: See chapter 6 for more details.
0
Send single logo in four rotations.
1
Send logo #1 of 2 in 2 rotations.
2
Send logo #2 of 2 in 2 rotations.
93
Load Control Code Recognition Status: Some mainframe, mini-computer, and
special-purpose computers cannot send ASCII characters under 20 hex or send
these numbers for reasons other than 410 ECA operation (spooler initialization,
etc). In order to maintain proper flow control, the 410 ECA printer will ignore
everything under 20 hex if so directed. There is also an EEPROM dip switch (see
section 5.3) that will enable the printer to enter this mode upon power-up. (Note: if
control code recognition is disabled, the printer will not process the 1Bhex (ESC)
character and therefore will not be able to store data streams.)
0
Enable control code recognition.
1
Disable control code recognition.
))))))))))))))))))))))))))))))))))))))))))))
410 ECA Operators Manual
Printer Commands
49
Advertisement
Table of Contents
Need help?
Do you have a question about the 410 ECA and is the answer not in the manual?
Questions and answers