BVM PNP F-86 Construction And Operating Manual page 7

Use a 1.5mm hex wrench to loosen the set
screw that retains the axle. Check to see if
there is a flat spot ground in the axle. If not,
use a dremel cutting disc to make one as
shown. A matching cutter mark on the end of
the axle helps to properly orient it.
Apply Parker Super "O"Lube to the brake
"O"Ring and on wheel inner drum.BVM
#5779
Apply Super Axle Lube BVM # 5784 to the
axle from inside and outside access. Note
the nylon spacer.
Reassemble the wheel, brake, and axle. Use
a small drop of thread locker on the set
screw. Check for free spin of wheel and
brake application.
Accomplish for both mains and the nose wheel. Of
course, the nose wheel does not have a brake.
BVM®2017 6 11/07/2017