Commissioning; Configuration And Operation; Indicators Used In Operation - Beko METPOINT FLM SF53 Installation And Operating Manual

Thermal flow meter

Hide thumbs Also See for METPOINT FLM SF53:

Table of Contents

5. Commissioning

To commission the METPOINT

Following this, slowly pressurise the pipes.

6. Configuration and operation

After powering up, the METPOINT

The device menus are operated through two capacitive buttons:

>>UP<<

>>ENTER<<

Gasart /

Statusmeldung

HW-Version

SW-Version

Press the >>UP<< button to access pages 2 to 5.

METPOINT

SF53

FLM, power it up and perform the sensor setup as described in "Sensor Setup" on Page 28.

FLM completes an initialisation procedure and then switches to showing the main menu.

Modbus ID

Seiten Nr.

CAL

is a calibration indicator:

After 15 months have elapsed, a pending recalibration is

indicated by

CAL

being shown on the display. This indicator

has no effect on measurement data. The measurement signal is

output as before.

The reminder time interval can be adjusted to customer

requirements at the manufacturer's works.

Installation and operating manual

Table of Contents