JLG 450A Service And Maintenance Manual page 58

7. Oil spindle, then lower hub (1G), small end down,
onto spindle (1A).
8. Press bearing cone (1F) onto spindle (1A) in hub
(1G).
9. Place spacer (1H) onto spindle (1A) in hub (1G).
NOTE: Make sure the retaining ring is securely seated in the
groove.
3120869
10. Place retaining ring (1I) over the spacer onto spindle
(1A) in hub (1G).
Main Assembly
BEWARE OF SHARP EDGES IN COUNTERBORE WHEN INSTALL-
ING THE O-RING
1. Grease o-ring (5) and place it into the counterbore in
hub (1G).
NOTE: O-ring may be stretched or pinched together to make
it fit the counterbore exactly.
– JLG Lift –
SECTION 2 - PROCEDURES
2-41