JLG 450A Service And Maintenance Manual page 32

b. Tap each space once; this means the tapered
bushing is tapped 3 times as there are 3 spaces
between the capscrews.
Figure 2-15. Seating the Tapered Bearing
14. Retorque the capscrews evenly and progressively in
rotation to the specified torque value. (See Table 2-1,
Cylinder Head and Tapered Bushing Torque Specifi-
cations.)
15. Remove the cylinder rod from the holding fixture.
16. Place new guide locks and seals in the applicable
outside diameter grooves of the cylinder piston.
(See Figure 2-28. Piston Seal Kit Installation.)
Figure 2-16. Poly-Pak Piston Seal Installation
17. Position the cylinder barrel in a suitable holding fix-
ture.
EXTREME CARE SHOULD BE TAKEN WHEN INSTALLING THE
CYLINDER ROD, HEAD, AND PISTON. AVOID PULLING THE ROD
OFF-CENTER, WHICH COULD CAUSE DAMAGE TO THE PISTON
AND CYLINDER BARREL SURFACES.
3120869
18. With barrel clamped securely, and while adequately
supporting the rod, insert the piston end into the
barrel cylinder. Ensure that the piston loading o-ring
and seal ring are not damaged or dislodged.
19. Continue pushing the rod into the barrel until the cyl-
inder head gland can be inserted into the barrel cyl-
inder.
20. Secure the cylinder head gland using the washer
ring and socket head bolts. See Table 2-1 and 2-3.
Torque Specifications.)(
Figure 2-17. Rod Assembly Installation
21. After the cylinder has been reassembled, the rod
should be pushed all the way in (fully retracted) prior
to the reinstallation of any holding valve or valves.
22. If applicable, install the cartridge-type holding valve
and fittings in the rod port block, using new o-rings
as applicable. (See Table 2-2. Holding Valve Torque
Specifications).
– JLG Lift –
SECTION 2 - PROCEDURES
2-15