JLG 450A Service And Maintenance Manual page 14

SECTION 1 - SPECIFICATIONS
Number/Type
Components
Lube Points
18
Air Filter - Deutz
19 Air Filter - Isuzu
NOTES:
Lubrication intervals are based on machine operation under normal conditions. For machines used in multi shift operations and/or exposed to hostile envi-
ronments or conditions, lubrication frequencies must be increased accordingly.
* If necessary install grease fittings into worm gear housing and grease bearings.
DO NOT OVERGREASE BEARINGS. OVERGREASING BEARINGS WILL RESULT IN
BLOWING OUTER SEAL IN HOUSING.
**When changing oil in the Deutz oil cooled engine, drain both the crankcase and the cooler. When refilling it is acceptable to overfill crankcase (10.5 L),
capacity of both crankcase and cooler combined). Start engine, allow the engine to run until the thermostat opens (approximately 105 degrees C) cooler will
fill up within minutes; shut down and wait for approximately two minutes. Check oil level, fill oil to max marking on dipstick.
Updated 11-1-99
1-6
Table 1-8. Lubrication Chart
Capacity
Replaceable N/A
Element
Replaceable N/A
Element
Interval
Lube
3 6
1 Year
Months Months
600 hrs
150 hrs 300 hrs
N/A X
N/A X
– JLG Lift –
Hours
Comments
2 Years
1200 hrs
Or as indicated by condition indicator
Or as indicated by condition indicator
KEY TO LUBRICANTS
EO Engine Oil
EPGL Extreme Pressure Gear Lube
HO Hydraulic Fluid (Mobil DTE-11M)
MPG Multi-Purpose Grease
OGL Open Gear Lubricant - Mobiltac 375 or
equivalent
3120869