Brother HE 120 Operation Manual page 96

SE-BrotherE_sgml.book Page 90 Monday, June 30, 2003 3:44 PM
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
UTILITY STITCHES
Align the seam with the center of the zipper,
and then baste the zipper in place.
Wrong side of fabric
Basting stiching
Zipper
Remove about 5 cm (2 inch) from the end of
the basting on the outside.
Wrong side of fabric
Zipper basting
Outside basting
5 mm (2 inch)
Attach the presser foot holder to the right pin
of zipper foot "I".
I
Pin on the right side
Needle drop point
• For details, refer to "Replacing the presser
foot" (page 40).
90
3
Select stitch .
• For details, refer to "Selecting stitching" (page
47).
CAUTION
● When using zipper foot "I", be sure to
select the straight stitch (center needle
position), and slowly turn the balance
wheel toward you to check that the
needle does not touch the presser foot. If
a different stitch is selected or the needle
hits the presser foot, the needle may bend
or break.
Topstitch around the zipper.
Stitching
Right side of fabric
Basting stitching
End of zipper opening
CAUTION
● When sewing, be sure that the needle
does not touch the zipper, otherwise the
needle may bend or break.
Remove the basting stitching.