Nothing Appears In The Lcd; Operation Beep - Brother HE 120 Operation Manual

SE-BrotherE_sgml.book Page 172 Monday, June 30, 2003 3:44 PM
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
APPENDIX

Nothing appears in the LCD

If nothing appears in the LCD when the sewing
machine is turned on, the brightness of the LCD is
either too light or too dark. If this is the case, perform
the following operation.
Turn off the sewing machine.
Turn the power on while pressing any of the
display panel buttons.
Press or .
Turn off the sewing machine, then turn it on
again.
172

Operation beep

Each time a key is pressed or an incorrect operation is
performed, a beep is sounded.
■ For a correct operation
One beep is sounded.
■ If an incorrect operation is performed
Two or four beeps are sounded.
■ If the machine locks up, for example, because
the thread is tangled
The sewing machine continues to beep for four
seconds. The machine automatically stops.
Be sure to check for the cause of the error, and
correct it before continuing to sew.