Adjusting The Speed Of The Feeding Belt - Canon DADF-R1 Service Manual

Chapter 5
5) Press the push switch SW3 or SW4 on the ADF
controller PCB to adjust the degree of arching by
referring to the table.
T-5-17
Switch Change
SW3 Increases the
arching.
SW4 Decreases the
arching.
J16 J15
J1
J2
J4
CB1
SW1
J5
DSP1
SW4SW3SW2
J3
J6
F-5-96
6) At the end of operation, press the push switch
(SW2) on the ADF controller PCB once again.
The copy paper will be delivered, and the
adjustment value will be stored in memory.
5.3.3.3 Adjusting the Speed of the Feeding
Belt
MEMO:
Adjusting the speed of the feeding belt will
automatically adjust the speed of reversal.
1) Remove the screw [1], and detach the ADF
controller cover [2].
5-28
J14
J13
J12
IC8
J7 J8 J9 J10 J11
2) Set the DIP switch (SW1) on the ADF controller
PCB as indicated.
3) Pres the push switch (SW2).
DSP 1 displays the current volume by flushing.
J16
J1
J2
J4
CB1
SW1
J5
SW4SW3SW2
J3
0013-3891
F-5-97
F-5-98
J15
IC8
DSP1
J6 J7 J8 J9 J10
F-5-99
[2]
[1]
J14
J13
J12
J11