Advertisement
Replacing a Front Panel LED Board
These instructions describe replacing a front panel LED board in a Spectra
T120 library.The light in the LED board is used to light the interior of the
library.
P
REPARE FOR THE
Replacing this component takes about fifteen minutes. Follow the
guidelines in these sections as you prepare for the replacement procedure.
Ensuring ESD Protection The repair environment for the library must be
free of conditions that could cause electrostatic discharge (ESD). To
protect the library from ESD, follow these procedures when repairing or
testing the library:
Gathering Tools and Supplies You must have the following to complete
this procedure:
R
EPLACEMENT
Place a static protection mat on the work surface used while removing
and installing library components. Use a 1-megaohm resistor to ground
the static protection mat.
Wear a static protection wrist band whenever you handle library
components that have been removed from their antistatic bags. Connect
this wrist band to the static protection mat or to other suitable ESD
grounding.
Keep all components in antistatic bags when not in use.
Required
A #1 Phillips screwdriver
A #2 Phillips screwdriver
A replacement Spectra Logic LED board
Recommended
An anti-static mat
A grounded anti-static wristband
3
Advertisement
