Advertisement
2.2 Disinfect the SeP
1.
Clean all surfaces of the SEP with a hard-surface
disinfectant/cleaner such as SaniZene
instructions on the container for application methods
and required contact time.
2. Hand wash the Support Arm Assembly with soap and
warm water. Rinse well with clear water, and dry with
a towel.
2.3 Re-Assemble the SeP
1.
Place the bracket of the longer tube onto the threaded
bolt near the bottom (longer end) of the SEP (Figure
12).
2.
Place the bracket of the shorter tube onto the threaded
bolt near the top (shorter end) of the SEP.
3.
Thread one inverted knob onto each of the bolts on
the SEP.
4.
Tighten one threaded knob into each of the holes of
the tubes.
5.
Use steps 2-5 on page 3 to attach the support arm
assemblies to the SEP.
6
Side Extension Panel 069-5796 and 000SEPKIT
. Follow the
®
Figure 12 - Re-Attach the Tubes to the SEP
Figure 13 - Re-Attach the Knobs
© Ferno-Washington, Inc 234-3488-00 April 2012
Advertisement
