Advertisement
9.
If the rubber stopper is not against the bottom of the
embalming table, turn the wingnut counterclockwise
to loosen the assembly (Figure 5).
10. Adjust the rubber stopper by turning it counterclockwise
till it firmly rests against the bottom of the embalming
table (Figure 6).
11. Once adjusted, re-tighten the wingnut by turning it
clockwise (Figure 7).
12. The attached SEP will look like the one in Figure 8.
4
Side Extension Panel 069-5796 and 000SEPKIT
Figure 5 - Loosen the Wingnut
Figure 6 - Adjust the Rubber Stopper
Figure 7 - Re-Tighten the Wingnut
Figure 8 - SEP Attached to the Embalming Table
© Ferno-Washington, Inc 234-3488-00 April 2012
Advertisement
