Limitations On Use - Dräger X-plore 8000 Instructions For Use Manual

en |
Description
3.4

Limitations on use

In ambient atmospheres with oxygen deficiency, the
facepieces can only be used in combination with a
compressed air hose unit, as they do not supply oxygen.
When used in combination with a powered air-purifying
respirator, the facepieces are not suitable for use in ambient
atmospheres with oxygen deficiency. Therefore, do not enter
unventilated containers, e.g. pits, ducts, etc. with the Dräger
X-plore 8000 facepieces and powered air-purifying
respirators!
The following factors can impair the protective effect of the
facepieces:
– High wind speeds and strong crosswinds.
– Earpiece or beards in the sealing cuff area.
3.5 Approvals
The Dräger X-plore 8000 helmet with visor is approved
according to:
Standard
EN 397 (head protection)
ANSI/ISEA Z89.1 (head pro-
tection)
EN 166 (eye-guard)
ANSI/ISEA Z87.1 (eye-
guard)
The Dräger X-plore 8000 helmet/hood combination is
approved according to:
Standard
EN 397 (head protection)
ANSI/ISEA Z89.1 (head pro-
tection)
EN 166 (eye-guard)
The Dräger X-plore 8000 bump cap/hood combination is
approved according to:
Standard
EN 812 (head protection)
EN 166 (eye-guard)
14
Performance level/Marking
LD -30 °C +150 °C MM 440 V
a.c.
Z89.1, type 1, class G
1 BT 9 3
Z87+
Performance level/Marking
LD -30 °C
Z89.1, type 1, class G
2 F 3
Performance level/Marking
-
2 F 3
Legend:
Meaning of the marking according to EN 397
LD
-30 °C
+150 °C
MM
440 V a.c.
Meaning of the marking according to EN 166
1, 2
F
BT
3
9
Meaning of the marking according to ANSI ISEA
Z87+
Z89.1, type 1, class G
All parts comply with the requirements of the following
requirements:
– (EU) 2016/425
– (EU) 2016/425 as brought into UK law and amended
For information on the respective system approvals, please
refer to the instructions for use of the respirators listed in
section 3.3.
Declarations of conformity: see www.draeger.com/product-
certificates
Instructions for use |
Additional requirement for lat-
eral deformation
Test at very low temperature
Test at very high temperature
Test with molten metal
Electrical insulation test
Optical class
Protection against low energy
impacts
Protection against high-
speed particles at extreme
temperatures
Protection against liquid
droplets or splashes
Protection against melted
metal and hot solids
Polycarbonate (PC) visor
with impact rating
Helmet without protection
against lateral deformation
and without protection
against electrical hazards
Dräger X-plore 8000 Facepieces