2.8 Configuration DIP SW
The configuration DIP SW (switches) are used for setting operation configuration manually.
The functions of each DIP SW states are:
SW1 SW2 SW3 SW4 SW5 SW6
OFF
OFF
OFF
------ ------ ------
ON
OFF
OFF
------ ------ ------
OFF
ON
OFF
------ ------ ------
ON
ON
OFF
------ ------ ------
OFF
OFF
ON
------ ------ ------
ON
OFF
ON
------ ------ ------
OFF
ON
ON
------ ------ ------
ON
ON
ON
------ ------ ------
------ ------ ------ OFF
------ ------ ------ ON
------ ------ ------ ------ OFF
------ ------ ------ ------ ON
------ ------ ------ ------ ------ OFF
------ ------ ------ ------ ------ ON
Function
Ignore DIP SW6 SW5 SW4 settings
(Use software configuration for managed model)
Set TP Port in non-auto, 10Mbps, Full duplex mode
Set TP Port in non-auto, 10Mbps, Half duplex mode
Set TP Port in non-auto, 100Mbps, Full duplex mode
Set TP Port in non-auto, 100Mbps, Half duplex mode
Set TP Port in auto, 1000Mbps, Full duplex mode
Disable TP Port function
Set TP Port in auto, 10/100/1000Mbps, Half/Full duplex
------ ------
Enable flow control
------ ------
Disable flow control
------
Disable remote TP status auto-report function
------
Enable remote TP status auto-report on TP LEDs
Disable Link Fault Pass Through function
Enable Link Fault Pass Through function
-17-