Nortel CallPilot Installation And Configuration Manual page 76

Installing the server and connecting the peripherals
3 Remove the inner SCSI bracket from the inside of the cabinet.
See the following diagram:
Note: After you remove the bracket, refasten the screws in their original locations
inside the cabinet.
4
Refasten the inner SCSI bracket screws in their original locations inside the
cabinet.
You will use the top screw later to fasten the NTRH3502 SCSI cable's drain
wire.
5 Slide the 201i server into a pair of consecutive slots.
Notes:
The 201i server cannot be installed in slots 0 or 4 because these slots are
dedicated to other cards. For more information about cards and slots, refer
to the Option 11C Mini documentation.
76
Inner SCSI
bracket
Standard 1.0
G101587
CallPilot