Nortel CallPilot Installation And Configuration Manual page 40

Installing the server and connecting the peripherals
Inspect the site
Complete the "Site inspection checklist" on page 12 before installing the 201i server.
Installation overview
1. Unpack the 201i server (see page 44).
2. Inspect the 201i server for possible damage (see page 45).
3. If you are installing the 201i server into a Meridian 1 tiered system, do the
following:
Change the location of the secondary backplane (DS30x) connector on the
201i server (see page 50).
Replace the existing backplane (tip and ring) cable on the Meridian 1 with
the one supplied with the 201i server (NTRH3501) (see page 57).
4. Install the intermediate SCSI cable. This cable is used to connect the external
CD-ROM or tape drive.
For
Meridian 1
Option 11C
Option 11C Mini
5. Set the DIP switches on the modem (see page 89).
6. Set the following:
SCSI IDs on the CD-ROM and tape drives (see pages 91 and 93)
DIP switches on the CD-ROM drive (see page 92)
device termination on the CD-ROM and tape drives (see page 95)
7. Insert the 201i server into an available position on the switch shelf (see
page 98).
Note: The 201i server occupies two peripheral equipment slots.
40
See
page 60.
Two cables are required to complete the connection
between the 201i server and the SCSI device:
NTRH1408 and NTRH1410.
page 66.
Two cables are required to complete the connection
between the 201i server and the SCSI device:
NTRH1407 and NTRH3502.
page 73.
Only one cable is required to complete the connection
between the 201i server and the SCSI device: the
NTRH3502 cable that is provided in the CD-ROM and
tape drive kits.
Standard 1.0
CallPilot