Nortel CallPilot Installation And Configuration Manual page 68

Installing the server and connecting the peripherals
c. Remove the two screws on the right side of the Option 11C I/O panel.
d. Attach the intermediate SCSI cable bracket assembly, using the screws that
were removed previously, so that the SCSI connector appears on the right
side of the Option 11C cabinet.
See the following diagram:
3 Thread the cable up through the card cage.
Note: When routing the SCSI cable through the card cage, ensure the second
cable ferrite is placed halfway through the opening.
4
Connect the grounding braid on the intermediate SCSI cable to the card cage,
and tighten the screw.
5 Leave the low-profile right-angle SCSI connector loose for now. You will connect
it later to the 201i server faceplate.
68
A
C
D
Standard 1.0
B
Intermediate SCSI
cable bracket
assembly NTRH1407
G101554
CallPilot