Table of Contents
Advertisement
Installing hardware
Checking the hard drive(s)
Checking hard
drives
Customer-
supplied padlocks
Standard 1.0
To check that each hard drive is securely installed, follow these
steps.
Step
Action
1
Carefully check that each drive is securely inserted into the
bay by tugging gently on the black handle at the front of each
drive assembly.
2
If a drive assembly is loose, press down on the lever at the
top front of the assembly and pull the unit out of the bay.
3
Position the drive assembly in the guide rails.
4
Gently push the drive assembly into the bay until it docks with
the backplane connector and snaps into place.
5
Swing the bay door back into place. Rotate the thumbscrews
to secure the door.
6
Install a customer-supplied padlock if required.
7
Close the outer plastic door.
Caution: Risk of equipment damage. Handle hard drive(s)
carefully. Avoid even minor shocks to the hard drive to prevent
possible internal damage.
Three tabs are provided on the server chassis for customer-
supplied padlocks. One is located at the front hard drive bay
cover. There are two tabs at the rear of the chassis, one for each
side cover.
Nortel Symposium Call Center Server
1001t Hardware Installation Guide
2-17
May 1998
Advertisement
Table of Contents
