Table of Contents
Advertisement
Installing hardware
Connecting peripherals to the 1001t Server
Rear panel
connections
Connecting
peripherals
Standard 1.0
This table describes the details shown in the preceding
illustration.
Item
Description
1.
Peripheral connection panel
2.
ELAN Network interface/adapter card
3.
CLAN Network interface/adapter card
4.
AC power input
Note: The illustration shows a prototype server
with only two power supplies. Your server will be
equipped with three power supplies.
To connect peripherals and power cords to the 1001t Server,
follow these steps.
Step
Action
1
Make sure the machine is not plugged in to a power source.
2
Plug the keyboard connector into the keyboard DIN
connector at the rear of the chassis.
3
Plug in the mouse connector into its DIN connector. Check
the legend for correct connections.
4
Plug in the monitor connector. Tighten the screws on the
connector.
Note: Do not add any other peripherals (for example, a
printer). Other peripherals are not supported.
5
Plug the three AC cords into the back of the panel. Plug the
other ends into a wall receptacle or power bar.
Note: The illustration shows a prototype server with only two
power supplies. Your server will be equipped with three power
supplies.
Note: Do not turn on the server at this time.
Nortel Symposium Call Center Server
1001t Hardware Installation Guide
2-23
May 1998
Advertisement
Table of Contents
