Table of Contents
Advertisement
C900TTL-E | Installation Guide | 4.0
Figure 13: Result of arp –g Command
4.5
Using Telnet to Finish the
Configuration
If you are using Windows 98, refer to Section 4.5.1
Using Windows 98 Telnet.
If you are using Windows 2000/XP, refer to Section
4.5.2 Using Windows 2000 or Windows XP Telnet
on page 22.
4.5.1
Using Windows 98 Telnet
→
1. Select Start
Run to open a DOS window.
At the Run dialog box, type telnet and press
2.
the [ENTER] key.
The Telnet application should now be running.
3. Select Connect Remote System...
The Connect window appears:
18
IP Address Configuration Setup Instructions
4. In the Host Name field, type the IP address that
was assigned to the C900TTL-E.
In this example, the IP address is 172.17.10.70.
Type 1 into the Port field and accept vt100 in the
TermType field.
5. Click Connect and wait a few seconds for a failed
message to display: Could not open a
connection to 172.17.10.70.
6. Click OK. The Telnet window appears again.
7. Select Connect→Remote System...
8. This time, type 9999 into the Port field and accept
the other fields. Click Connect.
Bosch Security Systems, Inc. | 5/07 | 4998122718-02
The IP, MAC address, and port number
used in this example are not the same
numbers you are using. This is for
demonstration only, along with the
presented screenshots. Actual values differ.
Advertisement
Table of Contents
