Table of Contents
Advertisement
Installation Guide
Base Station
3.2.6 SECURE THE CABLE
For safety reasons secure the base station cable to a convenient point at about 30 cm
from the base station.
If for some reason the base station drops, it is secured by the cable.
3.2.7 PINNING
1
Cut the cable to the correct length and connect the cable to a RJ45 modular jack.
2
For information on the pinning of the data jack see the following:
•
IPBS,
•
BS3x0 and BS3x2,
Do not plug the connector in the base station yet!
NOTE: Since the distance between the base station and the wall is limited, a RJ45
modular jack without cable retention must be used.
Pin the IPBS Cable
RJ45
modular jack
Figure 11. Connector pinning of the LAN/PoE connector, power feed over the
RJ45
modular jack
Figure 12. Connector pinning of the LAN/PoE connector, power feed over the
32/1531-ANF 901 43 Uen B2 2016-04-01
Pin the IPBS Cable
on page 20.
Pin the BS3x0/BS3x2 Cable
1
2
3
4
5
6
7
spare cable pairs.
1
2
3
4
5
6
7
8
Rx/Tx data cable pairs.
on page 21.
8
Tx = Transmitter data pair
Rx = Reciever data pair
Pwr = Power pairs
Tx/Pwr = Transmitter & power pair
Rx/Pwr = Reciever & power pair
NC = Not Connected
20
Advertisement
Table of Contents
