Mitel Base Station Installation Manual page 5

Installation Guide
Base Station
Power Distribution
The IPBS4x0 can be powered using the following methods:
• Power over Ethernet, IEEE 802.3af
• A local AC-adapter
NOTE: For more information about power distribution, see
on page 22.
Software
The software in the IPBS4x0 can be updated by downloading new software without
disconnecting the equipment. The new software is stored in flash memory. For
information on how to update the software in the IPBS4x0, see the applicable
Installation and Operation Manual for the IPBS4x0.
Connectors
• Two 8-pin RJ45 modular jacks for LAN/PoE and powering
• A 6-pin RJ12 modular jack for factory testing
LEDs
Status of LED1 (lower LED)
Steady Green
Flashing fast amber
Steady Amber
Alternating red/green
Status of LED2 (upper LED)
Not lit
Steady green
Flashing slow green
Flashing red
Flashing fast red
Alternating red/green
2.1.2 IPBS440 WITH EXTERNAL ANTENNAS
The IPBS440 is available with two omni-directional external antennas. Other external
antennas can be mounted as well. This section contains the differences between the
IPBS4x0 with internal and external antennas. For all other information see
IPBS430 with Internal Antenna
32/1531-ANF 901 43 Uen B2 2016-04-01
Description
Operational
Download of firmware in progress.
TFTP mode
No Ethernet connection
Description
IPBS 4x0 operational and no traffic on the IPBS
4x0.
IPBS 4x0 operational and traffic on the IPBS
4x0.
Fully occupied with traffic.
No air synchronization - searching for air sync
candidates.
Download of RFP software in progress.
RFP not initialized.
on page 2.
3.3 Power the Base Station
2.1.1
3