Mitel Base Station Installation Manual page 14

Installation Guide
Base Station
Software
The software in the BS3x2 can be updated by downloading new software without
disconnecting the equipment.
Connectors
• Two 8-pin RJ45 modular jacks for data and powering
LEDs
The BS3x2 has one RGB LED to indicate status. This section describes the different
indications and when they shall be used. In the illustrations below: Each blink pattern is
represented by a number of blocks where each block is 100 ms. Light grey blocks
means that the LED is off. Whenever the indication is changed the new pattern always
starts from the first block.
Idle/OK
Starting up
Active traffic
Fully occupied
for speech traffic
Software
download
Error
32/1531-ANF 901 43 Uen B2 2016-04-01
Solid blue.
100 ms blue, 100 ms off.
400 ms off, 2000 ms blue.
400 ms red, 2000 ms blue.
400 ms blue, 600 ms off.
100 ms red, 100 ms off.
BS3x2 operational and no
traffic on the BS3x2.
The BS3x2 is in start-up
phase, i.e. waiting to be
initialized by the PBX.
BS3x2 operational and
traffic on the BS3x2.
Fully occupied with traffic.
Download of firmware in
progress.
U layer 1 communication
PN
error.
12