Husqvarna K970 III Workshop Manual page 52

4. Do the same with the other side of the crankcase.
5. Make sure there is no radial play on the connecting
rod by the crankshaft journal. If there is radial play,
the unit must be replaced.
6. Carefully clean the gasket surfaces.
6.12.6 To remove the bearings from the crankcase
Usually the bearing releases from the crankshaft when
the crankcase is disassembled. If not, you can remove
the bearing with the puller, refer to
overview on page 10 . To replace the bearing you must
52 - Repair and servicing
Servicing tools
use 2 Husqvarna bearing press kits, refer to
tools overview on page 10 .
1. Put the puller plate behind the bearing.
2. Attach the puller unit and press the bearing off from
the crankshaft.
Servicing
1444 - 001 - 02.04.2020