Husqvarna K970 III Workshop Manual page 56

clutch. If it is necessary, replace with a full clutch
assembly.
2. Measure the inner diameter of the clutch drum.
The inner diameter of the clutch drum must not be
more than 79.8 mm/3.1 in. If it is necessary, replace
with a new clutch drum.
6.13.3 To assemble the clutch
WARNING: Risk of injury. Assemble the clutch
with the correct tightening torque. Use a torque
wrench.
• Tighten the clutch with a torque of 37–43 Nm.
6.13.4 To remove the clutch springs
1. Put the clutch in a vise.
2. Put a large screwdriver against the end of the
spring. Hit the screwdriver with your hand to release
the spring.
56 - Repair and servicing
3. Remove the spring with a small screwdriver or a pin
punch.
6.13.5 To examine the clutch shoes and hub
CAUTION: Do not lubricate the clutch.
• Make sure that the clutch shoes move easily in their
grooves. Clean if it is necessary.
6.13.6 To install the clutch springs
1. Install the clutch springs with a small screwdriver or
a pin punch.
1444 - 001 - 02.04.2020