Husqvarna K970 III Workshop Manual page 20

8. Remove the inlet manifold.
9. Install in the inlet manifold in the opposite sequence.
Note: Make sure that the clamp is put fully together.
20 - Product overview for repair
and servicing
5.2.9 To remove the inlet nozzle
1. Remove the screw for the inlet nozzle.
2. Remove the the inlet nozzle.
3. Install in opposite sequence.
5.2.10 To remove the vibration damping units
1. Remove the air filter and the cylinder cover. Refer to
To remove the air filter on page 15 .
2. Remove the starter. Refer to
on page 14 .
3. Loosen the cable lug on the ignition module and on
the stop button. Remove the air line. Refer to
remove the air duct on page 18 .
4. Disconnect the water hose from the valve. Refer to
To remove the cutting head on page 15 .
5. Remove the fuel hose. Refer to
carburetor on page 16 .
6. Remove the throttle wire from the carburetor. Refer
To remove the carburetor on page 16 .
to
7. Remove the choke. Refer to
carburetor on page 16 .
To remove the starter
To
To remove the
To remove the
1444 - 001 - 02.04.2020