Husqvarna K970 III Workshop Manual page 25

6.1.6 To remove the spring assembly
WARNING: Always use protective glasses when
you disassemble the spring unit. Risk for eye
injuries, especially if a spring is broken.
1. Remove the 2 screws on the spring assembly.
2. Push out the 2 hooks from the snap locks with a
screwdriver.
6.1.7 To clean the spring assembly
Note: Do not remove the spring from the spring
assembly.
1. If the spring is dirty, blow clean with compressed air.
2. Apply a light oil on the spring.
6.1.8 Starter pawls
When the flywheel does not move, the starter pawls are
pushed in the direction of the center by springs. When
1444 - 001 - 02.04.2020
the flywheel rotates, the turning force pushes out the
center pawls.
6.1.9 To examine the starter pawls
Note: Do not lubricate the starter pawls.
1. Make sure that the springs operate correctly and the
starter pawls move freely.
2. If it is necessary, disassemble and clean the starter
pawls.
6.1.10 To disassemble the starter pawls
Note: The position of the washer is below the starter
pawls against the flywheel. Make a note of the position
of the springs in relation to the flanges on the flywheel.
• Remove the shoulder screws.
Repair and servicing - 25