Husqvarna K970 III Workshop Manual page 28

.02 in.
0.5 mm
1. Replace the spark plug with the test spark plug.
Servicing tools overview on page 12 .
Refer to
2. Move the stop button to the run position.
3. Ground the test spark plug.
4. Pull the starter rope handle as if you start the
product.
If there is a spark, the spark plug is defective. Replace
the spark plug. If there is no spark, examine the ignition
cable and the short circuit cable.
28 - Repair and servicing
6.2.6 To examine the ignition cable
1. Pull up the rubber seal by the ignition unit and
remove the ignition cable.
2. Put a pair of pointed pliers in the spark plug
connection and pull out the spring and cable end.
3. If the connection is defective, the ignition cable can
be made shorter. Make a new hole in the cable and
attach the connection spring.
4. The connection in the illustration can be used to
make sure that the ignition cable is not broken. The
battery is connected in series with a test lamp. A
resistance control can also be made with a
multimeter.
If there is no spark after this test, examine the short
circuit cable.
1444 - 001 - 02.04.2020