Husqvarna K970 III Workshop Manual page 65

3. Lift the lower part of the throttle trigger lockout and
pull it out from the pin.
4. Remove the screw and the right handle side.
5. Push out the spindle to the right side. Use a rod with
a diameter of 0.08–1.0 in./2–2.5 mm and minimum 4
in./10 mm in length and remove the throttle trigger.
1444 - 001 - 02.04.2020
6. Push out the spindle to the right side. Use a rod with
a diameter of 0.08–1.0 in./2–2.5 mm and
approximately 4 in./10 mm in length and remove the
throttle control wheel.
7. Remove the wire from the throttle control wheel.
6.16.2 To examine the throttle trigger lockout
The throttle trigger lockout operates correctly if the
throttle trigger is locked at idle speed.
• Make sure the throttle trigger cannot be released
until the throttle trigger lockout is pressed.
Repair and servicing - 65