Setting Mode Of Operation - Notifier RP-1001 Installation Manual

Installation Procedure
6HWWLQJ0RGHRI2SHUDWLRQ
24
www.PDF-Zoo.com
Select operating mode by setting the DIP switches on SW1; basic programming options are shown
in this section. After any changes are made to the configuration switches, the panel must be reset.
For Canadian use, refer to "Sprinkler Supervisory Tracking" in Section 3.8.
Battery Fail LED Ground Fault LED
DIP Switches for Basic Programming
Switch 1: Cross Zone
Switch 2: Dual Hazard
%DVLF3URJUDP
Select the desired mode of operation and set SW1 DIP switches 1 and 2 per the appropriate column.
Mode #1
Single Hazard
Two Zone
Outputs 1 and 3:
Activated by an alarm Activated by an alarm
on either Zone 1 or 2. on either Zone 1 or 2.
Output 2:
Activated by a
waterflow alarm on
Zone 3.
Output 4: Activated Output 3: Activated
by a supervisory by alarms on both Zone
condition on Zone 4.
Output 4: Activated
condition on Zone 4.
Note: Outputs 1 and 2 refer to Notification Appliance Circuits. Outputs 3 and 4 refer to
Releasing Circuits. Zones 1 and 2 refer to Initiating Device Circuits 1 and 2.
O
N
O
1 2 3 4 5 6
N
DIP Switches for Setting Discharge Timer
Switch 3: Discharge Timer
Switch 4: Discharge Timer
Switch 5: Discharge Timer
Mode #2
Single Hazard Dual Hazard
Cross Zone Combined Release
Output 1:
Activated by an alarm
on either Zone 1 or 2
or a waterflow alarm
Output 2:
Activated by a Activated by a
waterflow alarm on supervisory condition
Zone 3.
Outputs 3 and 4:
Activated by an alarm
1 and Zone 2. on either Zone 1 or 2.
by a supervisory

Setting Mode of Operation

1 2 3 4 5 6
Micro Fail LED
Switch 6: Not used
Mode #3 Mode #4
Dual Hazard
Split Release
Output 1: Output 1:
Activated by an alarm
on either Zone 1 or 2
or a waterflow alarm
on Zone 3. on Zone 3.
Output 2: Output 2:
Activated by a
supervisory condition
on Zone 4. on Zone 4.
Output 3:
Activated by an alarm
on Zone 1.
Output 4: Activated
by an alarm on Zone 2.
RP-1001 15150:F 05/24/2001