Table of Contents
Advertisement
Transparent Async Protocol (TRANS ASYNC)
1 DTE PORT 1
1 CONFIG
2 DTE PORT 2
61200.130L1-1
Transparent Async protocol frames up async characters to
transport across a frame relay network. This protocol is used
when the device connected to the FSU is an async device such as
a terminal or PC. See Figure 6-8 for the Transparent Async menu
tree.
1 PROTOCOL
2 PHYSICAL LAYER OPTIONS
3 PROTOCOL OPTIONS
4 PROTOCOL ADDRESS TABLE
The FSU buffers async characters from the DTE device until two
idle characters or 100 characters are received. A frame relay
synchronous frame is constructed containing the data content of
each character. Frame relay frames received on the network
containing transparent async data are transmitted to the attached
device with the character format set under the DTE port physical
layer options.
FSU User Manual
Chapter 6. DTE Port Configuration
6 TRANSPARENT ASYNC
1 INTERFACE TYPE
2 ASYNCHRONOUS BIT RATE
3 DATA BITS
4 PARITY
5 STOP BITS
6 HARDWARE FLOW CONTROL 1 OFF
N/A
1 FAR END PORT NUMBER
2 OUTGOING DLCI
Transparent Async Protocol Menu Tree
1 RS232
2 V.35
1 2400 bps
2 4800 bps
3 9600 bps
4 19.2 Kbps
5 38.4 Kbps
1 7
2 8
1 NONE
2 EVEN
3 ODD
1 1
2 2
2 ON
1 DTE PORT 1
2 DTE PORT 2
Figure 6-8
5 7
Advertisement
Table of Contents
