Canon Optura 400 Instruction Manual page 89

5. Press the AUDIO DUB. button on the wireless
controller.
"AUDIO DUB." and "
6. Press the PAUSE a button on the wireless controller
to begin dubbing.
• Audio device: Begin playback.
• Microphone: Speak into the microphone.
7. Press the STOP 3 button on the wireless controller
to stop dubbing.
Audio device: Stop playback.
❍ Use only tapes recorded in SP mode 12-bit audio sound with this camcorder.
Audio dubbing will stop if the tape has a blank section or a section recorded in
LP mode or 16-bit mode.
❍ When using the built-in microphone, do not connect any devices to the MIC
terminal.
❍ You cannot use the DV terminal for audio dubbing.
❍ If you add sound to a tape not recorded with this camcorder, sound quality
may decrease.
❍ Sound quality may decrease when you add sound to the same scene for more
than 3 times.
❍ When you connect an audio device, check the picture on the LCD screen and
the sound via built-in speaker or audio device. You can also connect a TV via
S-video terminal.
❍ When you use a microphone, you can check the picture on a TV connected via
the AV terminal and the sound via headphones connected to the TV. When
you connect a TV via S-video terminal, you can check the picture on the TV
screen and the sound with headphones connected to the camcorder.
❍ Set the zero set memory at the end of the scene you wish to dub audio. The
camcorder will automatically stop audio dubbing at that point.
a" appear.
ZERO SET
REW PLAY FF
MEMORY
12bit
STOP
AUDIO OUT
PAUSE SLOW 2
AUDIO DUB.
E
AV DV REMOTE SET
ZERO SET
REW PLAY FF
MEMORY
12bit
STOP
AUDIO OUT
AUDIO DUB. PAUSE SLOW 2
AV DV REMOTE SET
ZERO SET
REW PLAY FF
MEMORY
12bit
STOP
AUDIO OUT
AUDIO DUB. PAUSE SLOW 2
AV DV REMOTE SET
89