Canon Optura 400 Instruction Manual page 61

❍ The audio level can be changed when the green bar is displayed. We
recommend hiding the bar when you have finished adjusting to prevent
accidental changes.
❍ The microphone level resets to [AUTO] when you switch the program selector
to [.
❍ We recommend using headphones when manually adjusting the audio level.
Microphone Attenuator
Use the microphone attenuator if you need to lower the volume level or correct audio
distortion during recording or audio dubbing. Check the audio level with headphones.
CAMERA
*
Only when [AUDIO DUB.] is set to [MIC IN].
AUDIO SETUP
( 36)
Open the menu and select [AUDIO SETUP]. Select [MIC ATT], set it to [ON]
and close the menu.
Using Headphones during Recording
The headphones terminal also serves as AV terminal. Headphones can only be used
when "H" is displayed on the screen. If not, change the setting following the
procedure below.
CAMERA
VCR SETUP
( 36)
Open the menu and select [VCR SETUP]. Select [AV/PHONES H ], set it to
[PHONES H ] and close the menu.
Adjusting the Headphone Volume
CAMERA
AUDIO SETUP
( 36)
Open the menu and select [AUDIO SETUP]. Select [ H VOLUME], adjust the
volume with the SET dial and close the menu.
You can turn off the volume completely by turning the SET dial down until [OFF] appears.
Turn the SET dial up to increase the volume again.
*
PLAY (VCR)
PLAY (VCR)
PLAY (VCR)
CARD CAMERA
MIC ATT••••••OFF
CARD CAMERA
AV/PHONES ••AV
CARD CAMERA
HVOLUME•••••
E
CARD PLAY
CARD PLAY
CARD PLAY
61