Installation Procedures - FIC PT-2006 Manual

The PT-2006 has several user-adjustable jumpers on the board that allow you to
configure your system to suit your requirements. This chapter contains
information on the various jumper settings on your mainboard.
To set up your computer, you should follow these installation steps:
Step 1 -
Set system jumpers
Step 2 -
Install RAM modules
Step 3 -
Install the CPU
Step 4 -
Install expansion cards
Step 5 -
Connect cables and power supply
Step 6 -
Set up BIOS feature (Please read Chapter Three.)
CAUTION : If you use an electric driver to install this mainboard on your
chassis, please wear a static wrist strap and the recommended electric driver
torgue is from 5.0 to 8.0 kg/cm to avoid damaging chips' pins.

Installation Procedures

3.)
Chapter 2
13