Chapter 2 Installation Procedures - FIC PAK-2005 User Manual

The PAK-2005 has several user-adjustable jumpers on the board that allow you to
configure your system to suit your requirements. This chapter contains information
on the various jumper settings on your mainboard.
Before using the computer, you must complete the following steps:
n
Step 1 -
Set system jumpers
n
Step 2 -
Install system RAM modules
n
Step 3 -
Install the Central Processing Unit (CPU)
n
Step 4 -
Install expansion cards
n
Step 5 -
Connect ribbon cables, cabinet wires, and power supply
n
Step 6 -
Set up BIOS software (Please read Chapter Three)
WARNING: Excessive torque may damage the mainboard. When using an
electric screwdriver on the mainboard, make sure that the torque
is set to the allowable range of 5.0 ~ 8.0kg/cm.
Mainboard and components contain very delicate Integrated
Circuit (IC) chips. To prevent static electricity from harming any of
the mainboard's sensitive components, you should follow some
precautions whenever working on the computer:
1. Unplug the computer when working on the inside.
2. Hold components by the edges and try not to touch the IC
chips, leads, or circuitry.
3. Wear an anti-static wrist strap which fits around the wrist.
4. Place components on a grounded anti-static pad or on the bag
that came with the component whenever the components are
separated from the system.
Installation Procedures
Chapter 2
13