FIC PT-2006 Manual page 40

PT-2006 Mainboard Manual
Infrared Connector: IR
This connector supports the connection to your IR device. The IR port uses the
same IRQ as COM2 port, therefore you need to adjust this BIOS option when an
IR device is installed.
Standard Power Supply Connector: POWER
This 12-pin block connector is used for connecting to the standard 5V power
supply. In the picture below, notice that, in most cases, there are two marks
" P8" and " P9" on the surface of the connector. You have to insert the
" P8" plug into the " P8" section of the connector, and so forth for " P9" . Two
black wires must be in the middle.
38