FIC PT-2006 Manual page 58

PT-2006 Mainboard Manual
On-Chip Primary PCI IDE
When enabled, allows you to use the onboard primary PCI IDE.
The available options are: Enabled (Default), Disabled.
On-Chip Secondary PCI IDE
When enabled, allows you to use the onboard secondary PCI IDE.
The options are: Enabled (Default), Disabled.
USB Controller
If you do not use the onboard USB feature, this option allows you to disable
it.
The options are: Enabled, Disabled (Default).
Onboard FDD Controller
When enabled, the floppy diskette drive (FDD) controller is activated.
The options are: Enabled (Default), Disabled.
Onboard Serial Port 1
If the serial port 1 uses the onboard I/O controller, you can modify your
serial port parameters. If an I/O card needs to be installed, COM3 and COM4
may be needed.
The options are: 3F8/IRQ4 (Default), 3F8/IRQ4, 2E8/IRQ3, 2F8/IRQ3,
Disabled.
Onboard Serial Port 2
If the serial port 2 uses the onboard I/O controller, you can modify your
serial port parameters. If an I/O card needs to be installed, COM3 and COM4
may be needed.
The options are: 2F8/IRQ3 (Default), 3E8/IRQ4, 2E8/IRQ3, 3F8/IRQ4,
Disabled.
Onboard Parallel Port
Allows you to select from a given set of parameters if the parallel port uses
the onboard I/O controller.
The options are: 378H/IRQ7 (Default), 278H/IRQ5, 3BCH/IRQ7, Disabled.
UART 2 Mode
Allows you to select the IR modes if the serial port 2 is used as an IR port.
Set at Standard, if you use COM2 as teh serial port as the serial port, instead
as an IR port.
The options are: HPSIR, ASKIR, Standard (Default).
IR Function Duplex
56