FIC PT-2006 Manual page 59

This feature allows you to select the infrared data transaction way.
The options are: Half (Default), Full, HPKIR, ASKIR.
RxD , TxD Active
The feature allows you to select the active signals of the reception end and
the transmission end. This is for technician use only.
The options are: Hi, Hi (Default); Hi, Lo; Lo, HI; Lo, Lo.
Onboard Parallel Port
Select from a given set of parameters if the parallel port uses the onboard I/O
controller.
The options are: Disabled, 278H/IRQ5, 3BCH/IRQ7, 378H/IRQ7 (Default).
Onboard Parallel Mode
Allows you to connect with an advanced printer. Select SPP for standard
parallel port (SPP) used on IBM PC/XT, PC/AT and bi-directional parallel
port found on PS/2 system. Select Extended for extended parallel port. Select
EPP Mode for enhanced parallel port. Select ECP Mode for Microsoft and
HP Extended Capabilities Parallel Port. Select ECP+EPP Mode for both
ECP and EPP Modes ports.
The options are: SPP (Default), Extended, EPP Mode, ECP Mode,
ECP+EPP Mode.
ECP Mode Use DMA
If your select ECP mode to be the parallel port mode,
this feature allows you to select Direct Memory Access (DMA) channel.
The options are: 3 (Default), 1.
Parallel Port EPP Type
If you select EPP/SPP mode to be the parallel port mode, this feature allows
you to select the EPP type version.
The options are: EPP1.9 (Default), EPP1.7.
Award BIOS Setup
57