Install Expansion Cards - FIC PT-2006 Manual

PT-2006 Mainboard Manual

4). Install Expansion Cards

CAUTION :
1. Always turn the system power off before installing or removing any
device.
2. Always observe static electricity precautions.
See "Handling Precautions" at the start of this manual.
To install an expansion card, do the following:
1. Remove the chassis cover and select an
||||||||||||empty expansion slot.
2. Remove the corresponding slot cover
from the chassis. Unscrew the mounting
screw that secures the slot cover and pull
the slot cover out from the chassis. Keep
the slot cover mounting screw nearby.
3. Holding the edge of the peripheral card,
carefully align the edge connector
with the expansion slot.
4. Push the card firmly into the slot. Push down on one end of the
expansion card, then the other. Use this " rocking" motion until the add-in
card is firmly seated inside the slot.
5. Secure the board with the mounting screw removed in Step 2.
Make sure that the card has been placed evenly and completely into the
expansion slot.
34
Your PT-2006 features three 16-bit ISA Bus
and four 32-bit PCI Bus
This section describes how to connect an
expansion card to one of your system's
expansion slots. Expansion cards are printed
circuit boards that, when connected to the
mainboard, increase the capabilities of your
system. For example, expansion cards can
provide video and sound capabilities.
expansion slots.