Table of Contents
Advertisement
The PA-2010+ has several user-adjustable jumpers on the board that allow you
to configure your system to suit your requirements. This chapter contains
information on the various jumper settings on your mainboard.
To set up your computer, you should follow these installation steps:
n
Step 1 - Set system jumpers
n
n
Step 2 - Install System RAM modules
n
Step 3 - Install the CPU
n
Step 4 - Install expansion cards
n
Step 5 - Connect cables and power supply
n
n
Step 6 -Set up BIOS feature (Please read Chapter Three.)
n
n
CAUTION : If you use an electric drill to install this mainboard on your
chassis, please wear a static wrist strap. The recommended electric driver
torque is from 5.0 to 8.0 kg/cm to avoid damaging the chips' pins.
n
Installation Procedures
Chapter 2
9
Advertisement
Table of Contents
